Overloading the shredder can cause issues with the motor and transmission. Check the shredder's capacity: Make sure the shredder is not overloaded and that you are using it within its capacity.Here are a few things you can try to troubleshoot the problem:

If your Member's Mark micro cut shredder is experiencing a problem where it is making 12 pulses when shredding and works good in reverse, it is possible that there is an issue with the shredder's motor or transmission. If that does not work, try their Customer Service at: After the machine has cooled down, turn the on/off switch to off and then back to on. It is a safety factor in case you get something stuck, like a person wearing a tie, etc. Once you have solved the problem, you should oil the blades after every hour of use, it really makes it easier on the blades.Īlso, there is an internal 'heat switch' in the machine that will shut it down for about 90 minutes if the motor gets to hot. If the motor does not come on, there is a fuse inside the machine that may need to be replaced. Replace the unit on the basket (make sure it is facing in the correct direction) and squirt, or lightly pour mineral oil (or machine oil, or something like WD-40) directly on the rollers and let it absorb into the remaining paper for a few minutes then try running the unit. Pull out as much of the paper from the top and bottom that you can. If that does not solve the problem, Unplug the unit from the electrical, remove the top part from the basket. First, try running the blades in REVERSE, that is done by using the on/off, selector switch. Obstructions in the shredder's passageway, such as lodged paper or plastic, will put additional stress on an already stressed-out motor.Is sounds like you have a paper jam.

Remove any obstructions which could slow the motor further when the power is off. Likewise, the shorter the cool-down time, the shorter the next shredding cycle will be, since the motor may not have sufficiently cooled. The longer the wait, the cooler your motor will be the next time, which guarantees a longer cycle the next round. Aurora, another shredder manufacturer, suggests waiting 30 minutes to an hour between overheated shredding cycles to allow it to fully reset. Wait even longer than the minimum recommend duty cycle if your machine heats up to the point where it stops working. This will keep it from accidentally re-engaging or continuing to heat up after a shredding session. Turn your shredder off and unplug it after every use. Occasional shredding in shorter bursts of time will keep the machine from overheating, compared to continuous operation which will cause the shredder to heat faster. Schedule your shredding under this duty cycle amount.

Ativa mdm8000 shredder manual